PC preform heater module factory price

Thu, 09 Jul 2026 08:49:03 +0800

Introduction

We built this PC preform heater module with one thing in mind: stop the heat from playing games with you. It was designed for SIPA rotary machines, straight from the factory. The goal? Absolute consistency. You get an infrared lamp that delivers 100% power matching, so every single preform station gets the same, steady output. No more guessing. No more ups and downs.

Power and Dimensions: The Real-World Specs

Here’s the thing about heating cycles—they need muscle. This system runs on 400V, specifically chosen to handle the heavy current draw that makes those rapid heating cycles possible. And the size? We made the tube 300mm long on purpose. It fits the tight space of the SIPA rotary turret without forcing you to tear apart your machine layout. Plus, at 2500W, it throws down the heat density needed to get preforms to the perfect stretch temperature in seconds.

Special IR radiator for PC/PETC

Mon, 22 Jun 2026 21:45:37 +0800

On the blow molding floor, uneven preform heating doesn’t just throttle line speed—it manufactures scrap. When the heating tunnel can’t hold setpoint across the neck and body, you end up with blisters, haze, and a weak biaxial stretch. The place to fix this is right at the emitter. What actually matters under the hood We built this IR radiator for PC/PETC around a short-wave quartz element, matched to how polyester and carbon-loaded blends absorb energy. It runs on 240V and comes in standard wattages from 800W to 1500W, so it drops straight into existing R7s sockets—no rewiring. The filament geometry is tuned to give you a tight focal band, so the heat lands where the preform needs it—neck finish, transition, and body—without scorching the surface. You get fast thermal response, stable output for 5,000+ hours, and repeatable temperature control inside the tunnel. Why it plays in the real world This emitter was engineered for blow molders—Sidel, Krones, SIPA, Husky, SACMI, and Nissei ASB. It follows OEM heating zone geometry, so you get uniform wall distribution and consistent bottle weight. The payoff: fewer pinholes, better clarity, and cycle times that don’t drift. Energy use drops because the element hits setpoint quickly and holds it with minimal oscillation. Replacement frequency goes down, too, which means less downtime and less spare inventory on the shelf. The stuff you learn the hard way Installation is straightforward, but alignment is everything. Set the focal distance to the preform path per your machine’s spec—even a small offset will create hot spots. Keep reflectors clean and watch for oxidation; when reflectors go dim, you lose output. And respect the operating envelope: the quartz element performs best in a dry, well-ventilated tunnel. In humid conditions, protect the lamp ends and sockets, and verify voltage stability. If the voltage is shaky, the filament gets stressed early.

PC on Warm Patio Infrared Systems

PC preform heater module factory price

Introduction

Power and Dimensions: The Real-World Specs

Special IR radiator for PC/PETC